led install

[merv62]

Hello all, I want to run 12 volt wire's to a new led tube light 12v. Right now the original tube light is 120v it is located under the top cupboard between the stove and the sink (02 monty)any idea's on how to access that area? there is a 12v light over the stove i'm thinking i could splice into those wire's but i need to run them over to where the original 120v fixture comes thru. I was also thinking about removing the inside shelf but they put a lot of those little tiny stappels in it and i would probably destroy the shelf so here i am-----sorry for the long post merv

[merv62]

I figured it out have to remove microwave and feed the other wires in through there not much room between the bottom and the shelf maybe 1/2"

[Ozz]

It is a challenge to route wiring in these things, but usually can be done. Congrats on the detective work. Can you post pictures?
Ozz