I got back yesterday from the dealership, they had worked on replacing the hydraulic jack on the bed slide. That works now, but the Lippert auto leveling system will
NOT auto level. It will go through the sequence to auto level and to the naked eye it looks level. and I wait for the beep that it's done leveling.
It has the green dot in the center of the four arrows and the next thing I should here the beep and should be done, but then the driver side levels take off and start to raise the 5th wheel higher it will get the tires off of the ground about 6" and I'll stop the system by tuning it off (FAST).
I have noticed that the whole time the system is on the right arrow is always flashing the red LED even during the auto leveling. I think this is where my problem lies.
I did go through and did the zero leveling. had the unit level (manually) and did what Lippert instruction said to do all was good with that.
I'm just waiting for the dealership to call Lippert to find out what's going on. The dealer seams to think the control board went bad. I find it hard to believe that this just seam to happen at the same time they been working on the Lippert hydraulic system.
I also get a message (sometimes) when I try to manual level, the angle is to steep, I'm setting on level concert no angle.