|
Another A/C question
Ok, I got on the roof, removed the cover. Things look fine, no clogged vanes, but will spray with water anyway. Is there any thing else I need to check while there?
Condensation collects in the bottom pan, but the drain holes are up hill because of the slant of the unit. This means it stays collected in the bottom/rear section of the pan until it evaporates. It gets deep enough to cover the bottom edge of the coil. Seems like this might cause a corrosion or other problem. Would I be wise to drill a small hole in the bottom/rear corner to facilitate better draining?
|
Threaded Mode
