|
Since it involves the outside outlet I am pretty sure that it is wet. If you want to check it take out the screws holding it to the side of the rig and wiggle it off the side. Look for loose caulk around the whole outlet, chances are that you will find a small area wher it was not sealing. The outlet is most likely wet inside. If so than just dump any standing water out of it and let it air dry. When you remount it use either the butyl tape or bed it in a good silicone caulk. I have found that the butyl tape works best as it is highly sticky and very durable... Dave
|
Hybrid Mode
