Word of warning ... on the Lippert Hydraulic Slideout Manual pages 9 & 10, the photos showing the nuts on the cylinder ram are NOT correct! If you notice on your unit as from the factory there is a gap of an inch or more between the outer locknut and inner jam nuts ... that's not a misadjusted slide ram, but the way it is supposed to be. Basically you want the ram physically to extend and retract fully in both directions and seal correctly at the same time. If you tighten up the 3 nuts on the ram as in the manual photos, this will cause more problems than you already have including broken parts. PM MIMF2 for good and precise instructions.
|