|
|
03-15-2015, 12:29 PM
|
#1
|
Montana Master
Join Date: Feb 2007
Location: Winfield
Posts: 7,327
M.O.C. #6846
|
Cabinet Struts and Magnetic Cabinet Latches
Got energetic again today and pulled out the pending mod list and decided to wipe a couple of items off of it. I had been planning on installing magnetic cabinet latches on all cabinets to supplement the OEM latches that as everyone knows are not the best. We have been strapping cabinets with Velcro and are hopeful that the magnetic latches will eliminate the strapping exercise. They seem to hold well on the pull tests that I did, so time will tell if it cures the opening cabinet problem. I also added them to some of the drawers but ran out of latches. Also completed the cabinet struts for the bedroom over-the-bed cabinets to eliminate having to hold them open since they open vertically. Here are a couple of pics of what was done. Still have about eighteen magnetic latches to install after installing seventeen today.
Representative pics of the latches and strike plates:
and the finished cabinet struts on the bedroom cabinets:
All in all, a pretty satisfying day of accomplishments.
Bingo
__________________
Bingo and Cathy - Our adventures begin in the hills of WV. We are blessed by our 2014 3850FL Big Sky (previous 2011 3750FL and 2007 3400RL) that we pull with a 2007 Chevy Silverado Classic DRW CC dually.
|
|
|
03-15-2015, 01:41 PM
|
#2
|
Montana Master
Join Date: Feb 2007
Location: Fayetteville
Posts: 2,351
M.O.C. #6831
|
These mods will help. We did the same thing.
|
|
|
03-15-2015, 01:57 PM
|
#3
|
Site Team
Join Date: Jun 2011
Location: Wilsey
Posts: 18,799
M.O.C. #11455
|
We also did that and it helped for sure. Still velcro a couple due to what is in there. The struts made Joyce a happy camper.
__________________
Dick, Joyce, Diego, Picatso and Gustav
2017 3720 RL, and 2013 HC 343RL
Pullrite Hitch, IS, Disk Brakes, 3rd AC, Winegard Traveler, Bathroom door mod, Dometic 320, couch for desk swap, replaced chairs, sun screens, added awnings, etc.
|
|
|
03-15-2015, 03:05 PM
|
#4
|
Montana Master
Join Date: Feb 2012
Location: Lake Gaston
Posts: 8,773
M.O.C. #12156
|
Very nice
__________________
Mike and Lorraine
2002 3655 FL, 2005 3650RK
2010 3665RE, 2015 3910FB
F350 crew cab dually 6.7
|
|
|
03-15-2015, 03:30 PM
|
#5
|
Montana Master
Join Date: Feb 2004
Location: Brandon
Posts: 3,944
M.O.C. #1034
|
We did the struts, guess now it's time to count up the latches required, nice!
__________________
Darwin & Maureen DeBackere
Minnedosa, Manitoba, Canada
2011/3500/Silverado/4x4/DRW/Duramax
2017/3721RL/Legacy Pkg./Pressure-Pro
|
|
|
03-16-2015, 03:39 AM
|
#6
|
Montana Master
Join Date: Nov 2013
Location: Willow Spring, NC
Posts: 992
M.O.C. #13909
|
Bingo, we don't have the overhead problem in the 3402RL, but I'd like to loose the Velcro as well. I can't wait to hear a report of how the cabinet magnetic latches work after a road trip.
__________________
Jim & Martha Abernathy
2014 Montana 3402RL Level UP, Sailun S637's, TST 507, 500W solar
2014 Ram 3500 Laramie® 4x2 diesel dually crew-cab 3.73 axle, Reese R20
|
|
|
03-16-2015, 04:03 AM
|
#7
|
Montana Master
Join Date: Feb 2007
Location: Winfield
Posts: 7,327
M.O.C. #6846
|
The first true test will be in May for Cathy's Masters Degree graduation at Liberty University. No better test than a trip down the West Virginia Turnpike!! Will update the thread with the results.
Bingo
|
|
|
03-16-2015, 12:29 PM
|
#8
|
Montana Master
Join Date: Feb 2004
Location: Pahrump
Posts: 2,523
M.O.C. #1081
|
bncinwv: Did you get the struts at CW?
|
|
|
03-16-2015, 04:09 PM
|
#9
|
Montana Master
Join Date: Feb 2007
Location: Winfield
Posts: 7,327
M.O.C. #6846
|
Quote:
quote:Originally posted by PackerFan
bncinwv: Did you get the struts at CW?
|
Yes, I just used the single screw attachment kind for the cabinet wall since they worked for us just fine in the 3750FL. Some have recommended the double bracket kind (two screws on each end) as being better, but as mentioned, we have had no experience with the ones we used.
Bingo
__________________
Bingo and Cathy - Our adventures begin in the hills of WV. We are blessed by our 2014 3850FL Big Sky (previous 2011 3750FL and 2007 3400RL) that we pull with a 2007 Chevy Silverado Classic DRW CC dually.
|
|
|
03-19-2015, 12:58 PM
|
#10
|
Established Member
Join Date: May 2012
Location: Fort Calhoun
Posts: 31
M.O.C. #12547
|
Hi
I have the cabinet struts,but have not mounted them.
How do you determine where to attach them?
I have no instructions and do not want to randomly screw holes.
Any suggestions would be welcome.
Thanks
|
|
|
03-19-2015, 03:26 PM
|
#11
|
Montana Master
Join Date: Feb 2007
Location: Winfield
Posts: 7,327
M.O.C. #6846
|
If you have the same type of doors and the struts from CW, I measured down from the inside of the cabinet facing 5 and 3/4 " and marked the place for the screw. Then took a drill bit and drilled a hole smaller than the screw. Don't forget the cabinets are hard wood and you will have to drill a pilot hole for all screws. The next step was to screw the bottom round end of the strut to the inside of the frame. The door was then lifted to the desired opened height (just short of the ceiling is where I chose) and the strut was swung up and placed against the back of the door and the holes marked for drilling in the door. Be sure to check that the strut body itself will not contact the cabinet facing during this step. Careful drilling the door, you do not want to go clear through. I used a piece of tape on the bit that set the length of the screw. If you follow this procedure, assuming your cabinets are the same over the bed or over the microwave ones, it is a snap to install the struts.
Bingo
__________________
Bingo and Cathy - Our adventures begin in the hills of WV. We are blessed by our 2014 3850FL Big Sky (previous 2011 3750FL and 2007 3400RL) that we pull with a 2007 Chevy Silverado Classic DRW CC dually.
|
|
|
03-19-2015, 06:42 PM
|
#12
|
Established Member
Join Date: May 2012
Location: Fort Calhoun
Posts: 31
M.O.C. #12547
|
Thanks Bingo for that info!
Warren
|
|
|
03-20-2015, 05:44 AM
|
#13
|
Montana Master
Join Date: Sep 2013
Location: Pensacola (mail forward service)
Posts: 3,198
M.O.C. #13740
|
Will be driving downto ft myers to get a strut for over the microwave. I have about four examples where factory did not drill and split out the stiles...which I had to glue and clamp, etc. So heed bingo's advice to pre-drill...don't be sorry afterwards. John
__________________
2012 F350 6.7 L dually, 2013 3800RE with 6 pt leveling, Sumitomo 17.5" load range h tires, Samsung 18 cu ft residential fridge, 8k Morryde I.S. with disc brakes. Full timing since 2012.
|
|
|
03-20-2015, 03:51 PM
|
#14
|
Montana Master
Join Date: Feb 2007
Location: Fayetteville
Posts: 2,351
M.O.C. #6831
|
To add to what Bingo said, I used the metal hook from Command Strip as the third hand. The hook held the door open at just the right height. This allowed you to be able to use both hands to install the struts. See the link below. This is a slide show. Pause on the cabinet. The other picture is my autoformer setup.
http://s858.photobucket.com/user/GPe...ow/3850%20Mods
|
|
|
08-15-2015, 09:36 AM
|
#15
|
Montana Fan
Join Date: Mar 2015
Location: Caledonia
Posts: 345
M.O.C. #17151
|
We took our first long trip with our new 2015 Montana Mountaineer 310RET over the Memorial Day weekend, from NE of Detroit to near Morris, IL. Upon arrival I found the RH lower kitchen cabinet had opened. After closing I began extending the room slide and heard the sickening sound of crunching wood. I hadn't noticed the LH lower kitchen cabinet door had opened as it was hidden by the slide moulding. Fortunately, it only popped the hinge screws and was easily repaired. After looking around and discussing with others in our camping club we decided to add Dreambaby mag Locks. We found them to make the doors virtually impossible to open once latched and can't be seen from the outside so aesthetic quality is maintained.
__________________
John & Laura___& Bentley
2017 Montana 3950BR
2015 GMC Sierra Denali Dually
|
|
|
08-16-2015, 04:32 PM
|
#16
|
Montana Master
Join Date: Jun 2010
Location: Colorado Springs
Posts: 3,335
M.O.C. #10496
|
A great idea. Thanks.
Quote:
quote:Originally posted by Former StClairSailor
After looking around and discussing with others in our camping club we decided to add Dreambaby mag Locks. We found them to make the doors virtually impossible to open once latched and can't be seen from the outside so aesthetic quality is maintained.
|
__________________
2010 3150RL
LevelUp, Dual 6 volt batteries, Progressive Industries EMS HW50C, Honda EU2000i Generator, Bridgestone Duravis R250 tires, Torklift Glowstep Revolution Stairs, LED Tail lights
2015 RAM 3500 Laramie SRW LB CC Cummins 6.7L Aisin Trans B&W RVK3600
|
|
|
08-17-2015, 06:42 AM
|
#17
|
New Member
Join Date: Jul 2014
Location: St Clair
Posts: 4
M.O.C. #14500
|
Looks great, We have magnets & plates, need to just do it!
|
|
|
08-17-2015, 07:10 AM
|
#18
|
Montana Master
Join Date: Feb 2007
Location: Winfield
Posts: 7,327
M.O.C. #6846
|
As an update, after a tip to Florida and back, we still have a couple of problematic cabinet doors and a couple of drawers that insist they would rather be open than shut. I like the concept of the Dreambaby locks, and may use them as a supplement on the problem areas if the magnetic catches that I have installed cannot be adjusted a little more.
Bingo
__________________
Bingo and Cathy - Our adventures begin in the hills of WV. We are blessed by our 2014 3850FL Big Sky (previous 2011 3750FL and 2007 3400RL) that we pull with a 2007 Chevy Silverado Classic DRW CC dually.
|
|
|
08-17-2015, 02:37 PM
|
#19
|
Montana Fan
Join Date: Mar 2015
Location: Caledonia
Posts: 345
M.O.C. #17151
|
We'll be at the MOC Rally next month if anyone wants to see these magnetic cabinet locks.
John
__________________
John & Laura___& Bentley
2017 Montana 3950BR
2015 GMC Sierra Denali Dually
|
|
|
08-18-2015, 10:28 AM
|
#20
|
Montana Fan
Join Date: Dec 2014
Location: Traverse City
Posts: 149
M.O.C. #15913
|
I use these locks and they do not come open. The ball grip is adjustable.
http://www.leevalley.com/en/hardware...=3,41399,41405
__________________
2018 Ram 3500 dually
2014 3725RL
|
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|