|
04-08-2006, 01:02 AM
|
#1
|
Montana Fan
Join Date: Jan 2003
Location: Harrodsburg
Posts: 191
M.O.C. #93
|
Rear Ladder Repair
The top screws of my rear ladder have pulled away from the Montana outside wall. They have not come completely off. The gap is about 1 inch. I attempted to tighten but the screws are rusted.
Has anyone had any experience in replacing these screws. What type of screw are they and do I have to take the entire ladder off.
Thank you in advance for your feedback.
|
|
|
04-08-2006, 01:37 AM
|
#2
|
Montana Master
Join Date: Jul 2003
Location: Clearwater
Posts: 10,917
M.O.C. #420
|
I removed all the screws and replaced them with stainless screws purchased at Home Depot. You can also get them at Lowes.
Didn't remove the ladder as I replaced one screw at a time.
|
|
|
04-08-2006, 01:43 AM
|
#3
|
Montana Master
Join Date: Sep 2004
Location: Leona
Posts: 6,382
M.O.C. #2059
|
Glenn said it real good.
|
|
|
04-08-2006, 01:57 AM
|
#4
|
Montana Master
Join Date: Jan 2005
Location: North Ridgeville
Posts: 20,229
M.O.C. #2839
|
Stainless steel ladder screws are on my "improve the Montana list" You know once the average MOC member gets his camper home and implements all the "improvements" learned on this forum..it is a far better camper than came off the line.
|
|
|
04-08-2006, 03:54 AM
|
#5
|
Montana Master
Join Date: Oct 2005
Location:
Posts: 1,568
M.O.C. #4890
|
SS screws are a great improvement anytime you see the OEM plated screws starting to rust and I changed my screws in my window slider tracks over to SS. I think only the double pane windows have these screws.
|
|
|
04-08-2006, 04:21 AM
|
#6
|
Montana Fan
Join Date: Feb 2005
Location: Virginia Beach, VA
Posts: 328
M.O.C. #3149
|
I replaced my upper screws with Stainless Steel. One of the OEM actually sheared off.
I found it easier to remove the mounts from the RV, reassemble them on the ladder, then refasten to the RV. This was due to the angle at which the supports were mounted.
Note: Use some caulk onthe mounting screws to insure watertight integrity.
|
|
|
04-08-2006, 05:22 AM
|
#7
|
Montana Master
Join Date: Dec 2002
Location: Spring Hill
Posts: 2,725
M.O.C. #59
|
Will have to check about the ss screws but I had to remove my whole ladder and redo it. All of my spider bolts were rusted internally. Made sure your ladder has a drain whole at the bottom of the ladder otherwise the water can't get out.
|
|
|
04-08-2006, 08:19 AM
|
#8
|
Montana Master
Join Date: Nov 2002
Location: Oceanside
Posts: 20,028
M.O.C. #20
|
As Tom said, I highly recommend a drain hole in the bottom of the ladder. I drilled three holes in the bottom of the lowest rung on mine. Water does get into the ladder and collects in that run, eventually rusting through.
|
|
|
04-08-2006, 08:42 AM
|
#9
|
Montana Fan
Join Date: Feb 2006
Location: Loganville
Posts: 476
M.O.C. #5314
|
I also had to replace the screws and the supports that attach the ladder to the unit on my last Monty due to rusted screws that broke off on I-10 going through Louisiana. This is when I decided that carrying bikes on the ladder was not the best way.
I have not replaced the screw on my new unit, but it should be done, and the sooner the better. Also with SS.
|
|
|
04-08-2006, 12:41 PM
|
#10
|
Montana Master
Join Date: Nov 2003
Location: Drexel Hill
Posts: 897
M.O.C. #627
|
I also replaced the screws with stainless steel.I went a tad farther and repolaced just about every screw I could find on the outside of the Montana with stainless steel.The only ones that showed rust though where the ones on the ladder.
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
Similar Threads
|
Thread |
Thread Starter |
Forum |
Replies |
Last Post |
REAR LADDER
|
johncamtravel |
General Discussions about our Montanas |
6 |
10-06-2013 05:07 AM |
Ladder Repair
|
TheCoachPotatoes |
Repairs & Service |
4 |
09-26-2013 02:37 AM |
Rear Ladder
|
BandJ |
Montana Problems, Problem Solving & Technical Help |
5 |
01-01-2007 03:30 PM |
Rear Ladder Repair
|
BandJ |
Montana Problems, Problem Solving & Technical Help |
7 |
11-07-2005 03:23 PM |
Rear Ladder
|
lightningjack11 |
Montana Problems, Problem Solving & Technical Help |
0 |
05-09-2003 10:06 AM |
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|