|
Bill,
Pin 4 is 12 volt positive and pin 1 is ground. check with a volt meter to see if power is there. I have heard some trucks have to have the switch on for power to be there.
If you have power there and still no luck, check the wire junction box on your pin for Monty. I have seen a fuse in there.
You should be able to run the landing gear with your vehicle fuse at 40 amp. I found the slides can draw up to 40 plus amps so again the fuse is an issue as well as the size of the wiring in the truck.
Hope this helps.
|
Hybrid Mode
