When I replaced my front graphic, the instructions for removal came with the new graphics. Basically a good heat gun will get them off in pieces. You will need to wear leather gloves to protect your hand for the heat gun. The graphics will come off in pieces--who cares since you will not use them again.
Then a good cleaning is needed to remove all adhesive residue. I think they said to use benzene or acetone--so where protective gloves and a mask--. I still have enough of an outline left to see where the new ones went on. I cut the BIG mountain scene into pieces--cut along the white areas between the colored graphics. Then put them on in smaller pieces. I did it in 2009 and they still look great! and are still stuck on the Monty!
__________________
F-250 King Ranch Crew Cab 2012, Single Wheel, 6.7 L Diesel, Transfer Flow Internal 50 Gallon Fuel Tank, Upgraded Ford Software for 50 Gallon tank, 2006 3475Rl with Mor-ryde King Pin, 2nd AC, 2nd Battery, Pressure Pro TPMS, Wet Bolt Shackle Kit
|