Leaning to one side

[Bettiand Bill]

I have the 2008 3075 and I noticed that it has started to lean to the street side by about 2 inches. I checked the concrete slab and it is level. Checked the tire pressures and their the same, measured the height from the frame to the slab on both sides and thier the same in the back, but just over an inch differance in the front, lower on the street side. I made sure both landing legs were lifting at the same time. Any ideas?

[Ozz]

On many of the 3400RL's, the street side is heavier than the other side, and some sit lower there.
I installed heavier springs on mine on the street side to compensate. Not shure on yours.

[Krusher]

If you have the MorRyde LRE suspension, check and make sure the street side sheer springs (rubber mount) have not ripped. Had the same thing happen on my previous 2008 Carri-Lite and found this to be the cause.

[bncinwv]

and check the spring hangers on the suspension system. Sounds like you have something bent or worn out under there. If they are bent, you will be able to see it instantly, they should be vertical.
Bingo

[snfexpress]

As Bingo stated, Check the spring hangers! On our 3400, it leaned to the driver side (the heavy side) but the problem was actually a broken spring hanger.