EMS in 3750

[K0LCB]

Has anyone had experience hard wiring Progresive Industries EMS in a 3750FL?

[bncinwv]

Leonard,

Here are a couple of threads (one for a 3750 install and the other for the 3850 install) (same configuration) where I provided photos of the process. This is assuming there is a transfer switch installed. I know you remember it because you replied!! If there is no transfer switch, I think the location would still work provided the shore feed input line can be lengthened to that location, if not you may have to do some investigation beneath the stairs since that area is immediately adjacent to the breaker panel.
If you pull the basement panels, you can see everything that you have to work with in terms of available areas.

3750 install with Automatic Transfer Switch

3850 install with Automatic Transfer Switch

Hope this helps or at least gives you some ideas!

Bingo

[K0LCB]

Thanks, Mr. Bingo! I knew I'd seen that, but couldn't remember where. My ABC disease kicked in

[bncinwv]

I guess the big question is whether you have the automatic transfer switch or not. Either way, the 3750 is very receptive to the installation since the back of the breaker panel is easy to access from the basement. If you happen to not have the automatic transfer switch and do an alternative install, I am sure that pictures of the process will be a worthy forum addition! Hint, hint!!
Bingo

[K0LCB]

I will see what I can do. I just ordered the Progresive EMS today