Go Back   Montana Owners Club - Keystone Montana 5th Wheel Forum > GENERAL DISCUSSIONS > General Discussions about our Montanas
Click Here to Login

Reply
 
Thread Tools Display Modes
 
Old 10-14-2018, 08:19 PM   #1
Figit090
New Member
 
Join Date: Aug 2018
Location: Humboldt
Posts: 6
M.O.C. #22423
Things to check while coroplast underbelly is off?

MODS: perhaps this is better sorted to maintenance section. I didn't see that on my phone at first...

My girlfriend and I are full-time in an RV and I'm slowly going through the whole unit and addressing all the problems before winter hits.

We have a 2003 3295RK 35', in wonderful shape, but not without it's age issues.

I'd love tips on what to look for after I finish pulling the spare tire and coroplast from the steps back. I've already got the front off (fixed a leak)

Plan so far:

- seal rear end cap to the frame and/or close the hole behind the water heater letting cold air in

- fix mystery leak near galley tank.

- add supports to black tank, perhaps all (we just bypass currently, so they're rarely full)

- diagnose 12v failure in super slide (couch).

- discover why the main heating duct goes further than the kitchen counter, nearly to the rear end cap?? Does it vent to the underbelly?? Patch holes and shoddy construction in duct and/or replace with flex line...if it will fit.

-glance at hydraulic system for leaks (pump is only known leak so far and it's aweful lol)

- add bubble/foil type insulation below subfloor between floor supports where possible AND another layer below everything before replacing coroplast, or whatever it's called.

I just got done patching up the heating system from the furnace to the bedroom with fresh flex pipe and as much aluminum tape as I felt comfortable with. I patched holes in the careless Keystone construction (hole saws ruining nearby duct, bad joints, etc..). I still have a leak where the plenum duct connects to the main duct that runs to the rear, hopefully I can patch that later. My hoses near the heater are getting warmed by the leak...and I want as few bug entry holes as possible.

I've also bypassed the washer/dryer hookup because of a leak and we don't use them. I plan to bypass the vacuum breaker for the sewer flush system later after I verify that's ok (use one at the hose connection so I can avoid leaks in my sink area).
Attached Images
File Type: jpg IMG_20181014_165453981.jpg (201.2 KB, 2 views)
File Type: jpg IMG_20181014_133206810.jpg (137.3 KB, 2 views)
File Type: jpg IMG_20181014_142318804.jpg (173.8 KB, 2 views)
Figit090 is offline   Reply With Quote
Old 10-16-2018, 11:33 AM   #2
beeje
Montana Master
 
beeje's Avatar
 
Join Date: Oct 2015
Location: westminster md
Posts: 735
M.O.C. #17894
Replace the waste tank valves with Valterra valves while you are in there.
__________________
2014 GMC 3500 Dually diesel 4x4 CCLB Curt q24
2011 Montana 3455 SA 6 point level up Disc brakes
Progressive EMS Valterra tank valves Sailun G637 tires Adp fridge control All led lighting
beeje is online now   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Montana RV, Keystone RV Company or any of its affiliates. This is an independent, unofficial site.


All times are GMT -6. The time now is 04:42 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.