Relocate Kitchen Table?

[Bad Moon]

Our 2016 HC 310 RE has the kitchen table located too far toward the front of the slide. "Normal"-sized people cannot sit comfortably on that side of the table. I want to relocate it about 4 inches rearward. The center column of the table has 4 feet, each of which is screwed to the floor. Are these just screwed into the plywood subfloor, or into some structural member? If it is the former, relocation should just be a matter of unscrew it and screw it down in the new location. If it is the later, I will have to fabricate some brackets. Any thoughts?

[DQDick]

In our old rig it would just be screwed into the flooring.

[rmthelen]

They are just screwed into the floor, there is no special bracket for their attachment. Should be an easy move for you, it was for me.

[GregN]

Also check under the table. Mine has a catch, so the table can side back and forth to make more room and lock the top in place for traveling.

[1retired06]

Just make sure you have clearance when closing, if an issue with your particular floorplan.. When ours is closed, the table is a half inch from the kitchen counter. We once closed the slide forgetting to take the table extension out, and it hit the counter and pulled the table loose from the floor.

[WeBeFulltime]

Originally Posted by GregN

Also check under the table. Mine has a catch, so the table can side back and forth to make more room and lock the top in place for traveling.

Our 2012 3585SA is also like this. Can be adjusted (slid) either way to give more room where needed. Having grandchildren here often we never relatch ours and just slide it at will to adjust to their needs. Very easy.

[Bad Moon]

Thank you everyone for your responses!