Furnace Issue continued from Spring

[The Weekenders]

Thanks Phil! I was worried I would have to break the outside seal and remove the whole furnace assembly.

[Sinterior]

A friendly tip on re assembly, tighten the screws just enough to hold things in place but still movable, run the fan and if it does rub, you can still adjust the case around a little until it stops rubbing, then tighten the screws.

[pappy65]

Took trailer in last week for the furnace problem and a couple of other minor things. Dealer found the ground connection at the solenoid was bad. Pretty much what I suspected. Remember though, mine would try to light and then lockout. Just FYI

[The Weekenders]

We have had a pretty nice Indian summer so not much need for the furnace till now but I think the final outcome is the connectors to the sail switch were a bit corruded which I cleaned up. Working perfectly now. A least a simple fix. Thanks for following the drama