12 volt fuse labeling

[ACFD139]

I am needing a little help. Does anyone have a diagram/label of the 12 volt fuse panel? I need to work on the water heater, I have the breaker off. Any help is much appreciated.

[twindman]

Meaning no disrespect, but here is what I am sure others will say (correctly?):
Keystone..... Build diagrams???? Bwaaa haaaa haaaa!!!

[Montana Man]

The fusees should be labeled on the inside of the door that covers the fuses.

[AZ Traveler]

ACFD,

Your water heater will be powered by 110v ac vice 12v.

[rohrmann]

Originally Posted by AZ Traveler

ACFD,

Your water heater will be powered by 110v ac vice 12v.

There is both 120 volts AC and 12 volts DC. The 12 volts DC is what operates the gas side of the water heater and there should be a fuse that will disconnect that. It really isn't necessary to remove the fuse, just disconnect the wire at the water heater and tape the bare end. There is also 12 volts that go the the relay that turns on the 120 volts that is controlled by the inside switch for the Electric mode.

[mazboy]

that's a laugh. if they are marked they are listed on door.


THERE in no specific diagram at this time...