Dick, I found this quote from LonnieB.
Quote:In my opinion it isn't necessary to rotate trailer tires UNLESS you start to notice unusual wear patterns. If an unusual wear pattern is starting, you should have the tires looked at by a tire professional to determine the cause before rotating the tires. Usually there is a mechanical or operator problem causing the unusual wear that will need to be addressed.
Hub-Centric Balancing - This method uses the pilot hole (large center hole) of the wheel. The wheel and tire assembly is placed on the shaft of the balance machine, then a cone shaped device is slid over the shaft into the hole in the wheel and secured by a large wing nut. This centers the assembly on the machine IF the pilot hole is the true center of the wheel. This method is the most commonly used and is accurate most of the time.
Lug-Centric Balancing - This method uses the stud holes of the wheel. A special adapter plate with adjustable threaded studs is mounted on the balance machine. The tire and wheel assembly is mounted to the adapter plate with lug nuts. This method is unquestionably the best and in some cases the ONLY way to get the assembly centered on the machine. This method is very time consuming so it isn't used much unless requested by the customer or the pilot hole in the wheel is off center.
Dick,when I had my Goodyear G614's Mounted and balanced they use a Centric Adapter to balance them. This was from Discount Tires! Keep in mind,I had to ask for that type of balance.
Jack
P.S. Give CC a pat for us!
|