Two questions

[dvanostran]

We have a 3008 3685 SA and are also having problems with the plastic on the back of the glass door inserts bubbling. Our dealer indicated that Keystone had a bad supplier, now replaced. The dealer ordered all new glass inserts for the doors this past week. We were also advised not to take off the plastic as the plastic turns the glass into safety glass.

We are also having some issues with slow water flow from the kitchen sink. Bathroom and shower are fine. Any suggestions would be appreciated.

Hope this helps.

[Wiarton William]

I have read this thread one end to the other...It is a very informative and factual subject...there is lots here that is really good to know...I would suggest and wonder IF.....this thread should be put into the service/repairs area..the water/plumbing fixtures info is definetly a need to know item and is priceless.......I would also wonder if the original poster would consider changing the title so it reflects the actual subject.. it should go in the area where some of the replies by OZZ can also be accessed..... I suggest this because the title of the thread does not indicate what lies in the posts and could easily be overlooked by someone looking for the information it has to offer......

[Wiarton William]

I had the bubbling problem with the plastic backing too...I stabbed the bubbles with a pin and pressed the air out...I left the backing on as a safety measure...it remains to be seen if this will solve the air bubble problem..One of the few times in recent memory that while working with a sharp object I did not have to get myself sewn up afterward..