Mor/ryde king pin parts

[Sdgood1]

We have the mor/ryde pin box and the nylon pieces don't look to good. Tried a search for parts and didn't have much luck. Anybody else have to replace these?? 4 round pieces and it looks like 4 flat pieces on the sides. IF so where did you get parts. Have an email into mor/ryde, but thought I'd ask here too.

[prndl]

If you mean the side pieces that you use when you have a "capture plate" for a pullrite hitch you get them from pullrite.

[DQDick]

If those are bad you probably need to replace the rubber spring also. All parts you can get from MorRyde.

[LDMoore06]

http://www.morryde.com/uploads/downl...Manual_v12.pdf

Try this link.

[Sdgood1]

Pics should be under this BUT, they are here LOL!! second and third pics show the nylon pieces on sides!! Thanx everybody, I'm emailing with More/ryde as we speak. I'm wondering what capture plate I should be using??? I've got a B&W patriot. The pin that is on there looks like a normal pin to me. The pin is the only thing sticking down???? Wondering if maybe somebody put the nylon pieces on without knowing what they were for. They actually put them inside the pin up against the rods that run from to rear, using the holes that are there. I'm hoping More/ryde can send me pics or part numbers!! Thanx again

[Sdgood1]

OK Mor/ryde responded that I do NOT need those pieces if using a standard hitch!! I love saving money!!