|
05-06-2007, 12:29 AM
|
#1
|
Montana Fan
Join Date: Mar 2006
Location: Manakin-Sabot
Posts: 371
M.O.C. #5540
|
Low Voltage outlet - help
I was attempting to hook up my computer to an outlet on the slide in my 3075RL and the computer cord which has protection built in wouldn't let any power to the computer. So, I checked the outlet to see if it was working and it registers on my multimeter 94Volts. Both sides of the outlet are the same. Another outlet on the same circuit shows 120Volts. I took out the outlet but discovered this is nothing like home. The wires slide into metal blades that cut into the insullation enough to make contact without cutting the wire. Needless to say I don't know what to do next. Any suggestions on how to trouble shoot this one would be appreciated. Thanks, John
|
|
|
05-06-2007, 02:56 AM
|
#2
|
Montana Master
Join Date: May 2006
Location: Oakland
Posts: 887
M.O.C. #5811
|
Can you disconnect the plug and check the wires with your multimeter, perhaps the plug is bad. If the voltage is still low, trace the wire back to the previous plug and check the connections there, maybe a bad connection at that point. I agree with you about the plugs being different, I was quite surprised the first time I removed one.
|
|
|
05-06-2007, 02:58 AM
|
#3
|
Seasoned Camper
Join Date: Feb 2007
Location: Groton
Posts: 71
M.O.C. #6859
|
If it is on the same circuit as the outlet that shows 120v, then it can be assumed that the circuit is fine. I would guess a bad connection in the outlet itself.
Turn power off to the circuit, take the cover off the back of the outlet, and make sure the wires have a good connection to the strips. If they appear good, it could be a defective outlet.
Try checking the resistance with an ohm meter between the from and back of the outlet, and between the good outlet and the bad one, with power off.
You can get the outlets at most camper dealers or online.
Jim
|
|
|
05-06-2007, 03:14 AM
|
#4
|
Montana Master
Join Date: Jan 2005
Location: North Ridgeville
Posts: 20,229
M.O.C. #2839
|
Those crimped connections are throughout the camper, perhaps an attempt to prevent the wiring to shake loose when traveling or perhaps just "cost effective" Found a bad crimped connection in our sensor module causing a improper reading.
|
|
|
05-06-2007, 04:08 AM
|
#5
|
Montana Master
Join Date: Oct 2006
Location: Choctaw
Posts: 530
M.O.C. #6364
|
If you are checking for voltage, are you testing hot blade to neutral blade in addition to hot blade to ground terminal? First things first, the plug is polarized meaning that the blades on the outlet are of different sizes. The small blade is the hot, the larger the neutral and the round terminal is ground.
When you look at it from the back side of the outlet you see three wires. The black wire should be the hot (120 VAC), the white wire the neutral and the green is ground. The white and green (or bare copper) wires should have no voltage on them when tested If you place your test leads on the white and ground and read voltage you have a problem and require a service call unless you're comfortable working with electricity.
OK, here's a solution and you need spousal support to turn off breakers and as a safety observer.
1. Turn off the breaker to the circuit to access the defective outlet.
2. Close the circuit breaker and with power applied, check the voltage at the wires on the defective outlet. If you have 120 VAC on the black and white wires your connection to that outlet is defective and an attempt of reconnection is possible.
3. Turn off the breaker and try to get the outlet's blades to cut through the wire's insulation.
4. Close the breaker and check for 120 VAC at the blades. If you have the correct voltage present your job is done!!
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
Similar Threads
|
Thread |
Thread Starter |
Forum |
Replies |
Last Post |
Low voltage
|
vbbigsky |
Repairs & Service |
9 |
08-10-2015 07:38 AM |
Disappearing voltage?
|
dsprik |
Montana Problems, Problem Solving & Technical Help |
47 |
06-27-2009 03:14 AM |
Voltage at outlets
|
Cyrus |
General Discussions about our Montanas |
3 |
09-24-2007 03:22 PM |
Low Voltage
|
RLVoumard |
General Discussions about our Montanas |
24 |
01-08-2007 06:44 PM |
Low Voltage System
|
Montana_2035 |
Montana Problems, Problem Solving & Technical Help |
1 |
12-06-2004 06:07 PM |
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|