Micro/Conv. oven FRAME

[paulinbaja]

We have an 09 34RL. w/Sylvania Microwave/Covn. oven. When opening the door to the M/C oven the hinge side of the door hits the decorative frame. It appears the frame is a bit to small for the unit and the only way to prevent the "rubbing" of the door to the frame would be to cut the frame on that side. It would take only a small amount of cut, but I hate to do that. I can't move the frame from side to side as the holes for the screws wont allow that small amount of movement. I turned the frame upside down but the situation still existed.
Anyone with the similar issue, anyone with other ideas??

[steelpony5555]

Hmmmmmmm maybe pull the frame off and then move the Micro over if possible. Maybe there is some adjustment on the oven itself. Don't know for sure since I have not opened that up as of yet.

[paulinbaja]

Moving the M/C is a good answer but it is all set. There is a bracket and the opening in just that sixe. Good idea though. Thank you