So this last weekend I decided to finish insulating the water system supply lines in the belly. I had previous posted pictures of the supply lines behind the axles. Now I have finished the supply lines forward of the axles.
As previously done, I decided to tidy up the wiring, heat duct, and review the black and Grey water tank install. So lets start with a previously posted picture. The picture below is the existing water lines running to the forward basement. These lines travel about twelve feet before going up through a hole in the flooring. Both lines are cold water lines. However one goes to the hot water tank and the other stays cold.
Next picture shows lines and heat duct looking back at axle passenger side. I have already added insulation.
The next picture are the lines running forward passed black water flush fitting. And the picture after that is the black water flush fitting.
Black Water Flush
Picture of how to tidy up heat duct
Picture of 50 AMP and positive battery line Keystone installation way
My Way
Finally what the Grey and black water valves look like at the tanks. Look closely and you will see all the wiring just laying on top of the foil wrap. I used $2.00 worth of tie wraps and fixed all that.
The manufacture of the Grey water and black water tank is a company called Travel Star Products. They are located in Goshen, IN. The tanks are the same part number. Tank size is 24 X 63 X 8 in inches.
To do this mod you'll need:
3 hours of leisure time
4 each 6 ft lengths of pipe wrap at $1.39
$2.00 worth of tie wraps
$3.00 Roll of Duct tape
It is very easy to drop the passenger side panels to the mid point of the trailer (do not go beyond). Fold the ABS plastic belly sheet out of the way. Move the foil wrap and start insulating.
Happy Camping!
ed