Generator mounting

[Redrover98]

Just received my Onan MicroQuiet for my 2007 3475RL. I ordered the Montana,generator ready and I thought the Onan would bolt up to the plates in the compartment. They don't line up. Is there an adapter or mounting base that I should have ordered also. The rv is wired with an Onan remote switch in the bedroom, so Keystone must have rigged it for an Onan. Can anyone enlighten me on this?
Dee

[bsmeaton]

Dee -

Not the expert here, but I believe the Microlite is a smaller base than the standard Onan, which may be why the holes aren't lining up.

[Russ and Sandy]

I had the same hole alignment problem when I installed a Microquiet 4000 in our '03 2955RL. I was able to elongate the holes enough to make it fit. If I remember correctly. one was off about 1/2 inch. I just figured Keystone installed the wrong brackets or mis-welded them.