3295RK Awning Size

[Larry]

Long story short...lost the awning the other day. My buds knew I was going to trash the whole thing so while I was out they tossed it in the dumpster. My problem is I hadn't measured it yet, the dumpster was emptied and I don't know what size to replace it with.

If anybody has a 2006 3295RK, I would like to know what size awning you have.

Thanks
Larry

[Art-n-Marge]

You could try this: Look up at the rig where one end of the awning was attached. Then eyeball it straight down to the ground and start your tape measure there. Then extend the measure to the other side straight down from the other attach point. If you take this length to the awning supplier they can figure out the size of awning you had. A couple of inches off won't matter because awnings are typically in groups of sizes and you can pick the size closest to your measurement.

Best regards Larry!

[bigmurf]

Did you toss just the fabric? Do you still have the tube?

[Larry]

No, they tossed the whole thing. I can measure the width between the brackets, that should give me a pretty good estimate.

[sreigle]

Larry, I wonder if Keystone Customer Service would have at information? I know they can access the (invoice or build sheet?) and tell you what was on your rig when they sent it out to the dealer. So likely they can find out the awning part numbers and/or size for you. Might be worth a try. I don't have their number at hand but it's on their website at www.keystone-montana.com .

[Larry]

Thanks Steve, I'll give them a try.

[bigmurf]

If they threw the tube in the trash, tell them they own you $25 for the Aluminum at a recycle place.g

One of you guys with the same rig: Go out and look at the tag on the tube for the model number. The mfg. can tell everything from that number.

[Bill-N-Donna]

You may be able to get the information you need by giving Keystone a call with your VIN number.

On Edit: I have a 3295rk but it's a different year. (2002) If you think it would help I'll get you the measurments I have.