Slide adjustment

[Starhill]

I'm having trouble with one of our slides. When pulled in it runs close
to the floor or drags on the floor on the inside edge. Any suggestions
on where to look for how to adjust these?

[skypilot]

There are several threads in the archives for this -- MIMF (Dale) has posted some excellent instructions on line as well.

That said, basically run your slide out a bit and underneath you will see two carriage bolts with locking nuts. You want to loosen the locking nuts and then move then down just a little bit -- a little movement makes a big difference inside so make small adjustments. You may have to have someone inside bounce (jump) up and down a bit to have the slide move; then run it in and out a time or two to check the adjustment.

As I said, Dale has some excellent instructions posted and hope you or someone can find them. I'm on a slow connection so I have to apologize for not finding the post already . Best of luck.

[TLightning]

There's a pretty good explanation of slide adjustment in the Lippert manual.

[Starhill]

Thanks to you and Tom. I think I've got it adjusted correctly now.