Go Back   Montana Owners Club - Keystone Montana 5th Wheel Forum > MOC on M.A.R.S. > Maintenance
Click Here to Login

Reply
 
Thread Tools Display Modes
 
Old 05-20-2018, 12:16 PM   #21
dieselguy
Montana Master
 
Join Date: Feb 2005
Location: Haysville
Posts: 3,348
M.O.C. #3085
Shark Bite Fittings

Tom ... you said it all ... no fluxing and soldering, no pipe dope or tape, virtually no wrenches ... just cut the plastic (or copper) line square and push it on. The cutter is great, doesn't cost much, and near guarantees a successful install. It's more or less a "push-loc" fitting and we have hundreds and hundreds of them on machines with pneumatic actuators that run over 100 psi. Used them for years and years. This reference was just to show they are pressure tolerant over and above the water pressure in our fivers.
dieselguy is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Powered by vBadvanced CMPS v3.2.3

All times are GMT -6. The time now is 11:26 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.