HELP oil leak at manifold in level system

[hrlyrdr]

Deleted

[Slow Hand]

There has to be a O ring or some type of seal I would think. Do you have a RV shop near you they may be able to help you. Did you take it apart or did the leak just start on its own?

[hrlyrdr]

Ok so I deleted my original post but after 2 trips to town, 14 miles each way, and a half hand full of o rings, I need someone to tell me what o rings fit the top of the shaft that the solenoid slides up on. I HAVE talked to lippert and they said "just go to automotive parts store and get one"... I have been to 2 parts stores, a hydraulic shop, 2 camper parts stores, and a friends stash. I need a size that fits. The closest one fit better and I thought I had the leak fixed. But it is pushed out and starting to leak also. So if you have a size or happen to have some laying around please help me out. Thanks... I did try the search but I may just be a little too anxious, leaving tomorrow..

[beeje]

O-ring sizes can be a real PITA to determine. I go through this when trying to get them for my pool equipment. Best I can tell ya is, find a place near you that works on heavy equipment/Hydraulics and see if they have a selection of o-rings that may fit

[Theunz]

Harbor freight sells an O-ring kit with quite a few sizes for not much money. You probably spent more in fuel than the kit cost, and if you have the kit you should be covered for life.

[ChuckS]

QN70348 from Global o-ring

Cross Section .210''
Inside Diameter 4.350''
Outside Diameter 4.770''
Nominal CS 3/16
Nominal ID 4-3/8