3120 Tip to Tail

[SirCampsalot]

Not sure if this is the route we are taking as I would like a bit shorter than even the website specs. The problem being that most RV's at the 33' length you have to give up on quality. What is the actual length front of pin to back of ladder. We are moving from 37'4" and I would like to drop 2', but do really like the Montana and especially the 3120.

[Theunz]

On my 2015 3100rl legacy the actual length, measured using a plumb bob, from tip of nose to rear of ladder is 37' 5" vs the 35' 3" factory quoted length. Montana quoted in their brochure that measurements were from center of kingpin to rear of bumper (may of just said bumper). On my trailer there is about a foot and a half from the kingpin to the end of the front cap. The molded rear cap on the legacy package looks like it adds a few inches more than the standard cap and bumper. The contoured ladder also adds a couple of inches compared to the standard straight ladder. For a ballpark figure I would add a foot and a half to any of Montanas length figures, and two feet if a legacy for actual overall length.

[mootana]

Originally Posted by SirCampsalot

Not sure if this is the route we are taking as I would like a bit shorter than even the website specs. The problem being that most RV's at the 33' length you have to give up on quality. What is the actual length front of pin to back of ladder. We are moving from 37'4" and I would like to drop 2', but do really like the Montana and especially the 3120.

The 3120RL and 3121RL measure:
*35' from pin to rear wall (add 7" for ladder)
*36'5 from front of fiberglass cap to rear wall (add 7" for ladder)

*These measurements are for a unit without the optional Legacy package with rear fiberglass cap.