|
08-13-2015, 04:20 PM
|
#1
|
Established Member
Join Date: Jun 2014
Location: Wiggins
Posts: 34
M.O.C. #14355
|
Tire Pressure Monitoring System
I just bought a TireMinder TPMS TM66-M6. Read the instructions and looked at the video. Wondering if others have this unit, and if so, where was the transmitter mounted?
Tks in advance,
Rodger
|
|
|
08-15-2015, 02:11 AM
|
#2
|
Montana Master
Join Date: Nov 2013
Location: Willow Spring, NC
Posts: 992
M.O.C. #13909
|
Sorry, can't help since I have a TST-507
__________________
Jim & Martha Abernathy
2014 Montana 3402RL Level UP, Sailun S637's, TST 507, 500W solar
2014 Ram 3500 Laramie® 4x2 diesel dually crew-cab 3.73 axle, Reese R20
|
|
|
08-15-2015, 03:08 AM
|
#3
|
Site Team
Join Date: Jun 2011
Location: Wilsey
Posts: 18,799
M.O.C. #11455
|
That's a new one on me also.
__________________
Dick, Joyce, Diego, Picatso and Gustav
2017 3720 RL, and 2013 HC 343RL
Pullrite Hitch, IS, Disk Brakes, 3rd AC, Winegard Traveler, Bathroom door mod, Dometic 320, couch for desk swap, replaced chairs, sun screens, added awnings, etc.
|
|
|
08-15-2015, 04:43 AM
|
#4
|
Montana Master
Join Date: Oct 2006
Location: McKinney
Posts: 7,159
M.O.C. #6433
|
Not familiar with that model either, but the user manual says the transmitters are the devices that attach to the valve stems. Also included in the kit are the monitor and hardwired signal booster. Is it the booster you are asking about?
__________________
Bill & Patricia
Riley, our Golden
2007 3075RL (recently sold, currently without)
|
|
|
08-15-2015, 04:47 AM
|
#5
|
Established Member
Join Date: Jun 2014
Location: Wiggins
Posts: 34
M.O.C. #14355
|
You are correct Bill and Patricia. I am wondering about the hard-wired repeater. Tks for catching that.
Rodge
|
|
|
08-15-2015, 05:24 AM
|
#6
|
Montana Master
Join Date: Apr 2006
Location: Mesa az
Posts: 2,945
M.O.C. #5651
|
I have read that people mount them in the back window of the truck or in the front in the storage area of the trailer. When using the trailer you have a 12V supply handy.
__________________
Tom and Gail
2013 Mountaineer 362
2012 Silverado 2500
|
|
|
08-15-2015, 07:02 AM
|
#7
|
Montana Master
Join Date: Oct 2006
Location: McKinney
Posts: 7,159
M.O.C. #6433
|
Seems either position mentioned by Tom works, from previous posts I have read.
__________________
Bill & Patricia
Riley, our Golden
2007 3075RL (recently sold, currently without)
|
|
|
08-15-2015, 10:20 AM
|
#8
|
Site Team
Join Date: Jun 2011
Location: Wilsey
Posts: 18,799
M.O.C. #11455
|
On my TST system I mounted the repeater in the back window of the truck.
__________________
Dick, Joyce, Diego, Picatso and Gustav
2017 3720 RL, and 2013 HC 343RL
Pullrite Hitch, IS, Disk Brakes, 3rd AC, Winegard Traveler, Bathroom door mod, Dometic 320, couch for desk swap, replaced chairs, sun screens, added awnings, etc.
|
|
|
08-16-2015, 03:15 AM
|
#9
|
Established Member
Join Date: Jun 2014
Location: Wiggins
Posts: 34
M.O.C. #14355
|
Tks to all for the comments/suggestions. Think I will go with the forward storage area because of the availability of power.
|
|
|
08-16-2015, 07:24 AM
|
#10
|
Established Member
Join Date: Jun 2015
Location: Valparaiso
Posts: 18
M.O.C. #17508
|
I mounted the repeater in the back window with a little silicone, I ran the wires under the carpet to the bottom of the door jam (this just pops off with a screw driver)I have wires there for the rear view camera so I attached the repeater wires to the same wires that power the receiver to the camera. But running power along the door jams is a very easy job, and you can use a switch to control your device(s). To make it even handier I tested the larger (12ga)wires under the dash for power that is controlled by the ignition,splice into that and everything turns off when the truck is off. The only caution is there are a lot of wires under you door jam. make sure all wires are clear of the tabs that snap down to secure the jam.
|
|
|
08-24-2015, 04:06 AM
|
#11
|
New Member
Join Date: Jul 2015
Location: Yuma
Posts: 2
M.O.C. #17664
|
I mounted the booster in RH storage cabinet. A 12 volt connection is already located there along with the TV cable connectors. Run the wires behind the wall and connected to back of 12 volt mounting plate. Then anchored the booster to top of wall. Works good for me. Plenty of boost to pickup monitor. Easy to see the green power on light also.
I have a lot of respect for Tire Minder as it clued me new brake was dragging, not adjusted correct.
Hope this helped.
|
|
|
08-24-2015, 04:12 AM
|
#12
|
Montana Master
Join Date: Nov 2013
Location: Willow Spring, NC
Posts: 992
M.O.C. #13909
|
On my TST, I mounted the repeater in the front bedroom of the Monty. There's a 12v jack there in the very front.
__________________
Jim & Martha Abernathy
2014 Montana 3402RL Level UP, Sailun S637's, TST 507, 500W solar
2014 Ram 3500 Laramie® 4x2 diesel dually crew-cab 3.73 axle, Reese R20
|
|
|
08-24-2015, 09:31 AM
|
#13
|
Montana Master
Join Date: Nov 2009
Location: Wampum
Posts: 571
M.O.C. #9928
|
I have that system. Have you operated your unit without the repeater yet? I got the repeater with my kit but never needed it. All wheel monitors work fine and the signals are received by the dash mounted unit fine. Just say'n. Maybe you don't need the repeater.
However, that being said, I would mount the repeater in the rear window of my tow vehicle with velcro and run the power cord under the rear seat to a power source. Mounting in the front storage comp. is an option and power is generally easily accessable. But don't forget to turn it on and/or off as needed.
__________________
"What happens at camp stays at camp"
2018 3121RL
2016 Ford F350 SB SRW
|
|
|
08-25-2015, 07:29 AM
|
#14
|
Seasoned Camper
Join Date: Jun 2013
Location: Quincy
Posts: 71
M.O.C. #13543
|
I have same TPMS system in a 3150RL - I mounted the transmitter next to the 12 volt outlet in the basement where I tapped in to power with a small switch so as not to draw on battery if dry camping. It works just fine from there.
|
|
|
08-30-2015, 11:50 AM
|
#15
|
Established Member
Join Date: Jun 2014
Location: Wiggins
Posts: 34
M.O.C. #14355
|
Quote:
quote:Originally posted by dneal3408
I mounted the booster in RH storage cabinet. A 12 volt connection is already located there along with the TV cable connectors. Run the wires behind the wall and connected to back of 12 volt mounting plate. Then anchored the booster to top of wall. Works good for me. Plenty of boost to pickup monitor. Easy to see the green power on light also.
I have a lot of respect for Tire Minder as it clued me new brake was dragging, not adjusted correct.
Hope this helped.
|
|
|
|
08-30-2015, 11:52 AM
|
#16
|
Established Member
Join Date: Jun 2014
Location: Wiggins
Posts: 34
M.O.C. #14355
|
Dave:
Pls define "RV storage cabinet".
Tks,
Rodger
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|