Go Back   Montana Owners Club - Keystone Montana 5th Wheel Forum > MOC on M.A.R.S. > Montana Problems, Problem Solving & Technical Help
Click Here to Login

Reply
 
Thread Tools Display Modes
 
Old 02-23-2005, 01:39 PM   #1
Dave e Victoria
Montana Master
 
Join Date: Nov 2003
Location: Glendale
Posts: 1,219
M.O.C. #635
Loose TV in 3295RK

Our main TV is loose. It seems to be pivoting about the right corner. For the life of me, I can't figure out how it is suppossed to be fastened in. I remember from the Factory tour that they build from the inside out. I am afraid they fastened the TV down from the back before they installed the outside of the slide.

There is a fire place below the TV and i intend to investigate how to remove it and maybe get access to the TV from the underside.

Any ideas or experience would be much appreciated. This thing is heavy as well as fragile and I would like it secured.
Dave e Victoria is offline   Reply With Quote
Old 02-23-2005, 01:48 PM   #2
CountryGuy
Montana Master
 
Join Date: Mar 2003
Location: Tipton
Posts: 3,646
M.O.C. #191
Dave,

The TV's are held in place (at least on the ones we have looked at) with long screws, through say, the shelf above the TV, through and into the plastic housing of the TV.

NOW, if you have the fire place, I cannot help you one iota. We do not have the fireplace, and therefore when we found that the top screws holding the TV in (less than 2 months into ownership) had both broken, we had a rather easy time finding the screws.

ON our unit there were 2 screws holding the top and 2 holding the bottom.

Not that this info is a lot of help, sorry, we wish you all the luck in the world finding the clues to your hiding screws!

Carol
CountryGuy is offline   Reply With Quote
Old 02-23-2005, 02:26 PM   #3
William H. Collier
Montana Master
 
Join Date: Jan 2004
Location: Machesney Park
Posts: 534
M.O.C. #798
On ours there was 1 screw at the top and 2 in the bottom. The top screw could be accessed by removing the center speaker which could be popped out, the bottom 2 could only be accessed after the fireplace was moved. Just remove the front screws under the flip down covering the controls, romove that face plate and you will see screws on both sides of the inside of the fireplace, remove them and just push the fireplace in to access the 2 screws going into the tv.
Bill
William H. Collier is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Siding Loose Temecula Repairs & Service 5 11-24-2016 02:39 AM
Loose wire stiles watson Maintenance 5 03-27-2012 11:17 AM
How many have loose lug nuts? footloose Maintenance 32 07-03-2010 09:08 AM
Roof loose again Jetson Montana Problems, Problem Solving & Technical Help 17 03-23-2007 02:50 PM
110 VAC Loose Wire H. John Kohl Montana Problems, Problem Solving & Technical Help 2 01-07-2007 02:59 PM

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Montana RV, Keystone RV Company or any of its affiliates. This is an independent, unofficial site.


All times are GMT -6. The time now is 07:57 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.