Go Back   Montana Owners Club - Keystone Montana 5th Wheel Forum > GENERAL DISCUSSIONS > General Discussions about our Montanas
Click Here to Login

Reply
 
Thread Tools Display Modes
 
Old 02-02-2018, 05:16 PM   #1
milsutter
Seasoned Camper
 
Join Date: Jun 2015
Location: Granite Bay
Posts: 65
M.O.C. #17499
Send a message via AIM to milsutter Send a message via MSN to milsutter Send a message via Yahoo to milsutter
Rear Den Model Question

We wall betweena 3790RD & the partion between the kitchen &rear den has come loose. It is held into the wall by 3 screws. When I try to tighten the screws they do not tighten. Any suggestions?
milsutter is offline   Reply With Quote
Old 02-02-2018, 09:44 PM   #2
BuilderBob
Montana Master
 
BuilderBob's Avatar
 
Join Date: Sep 2017
Location: Tacoma
Posts: 1,102
M.O.C. #20475
Try putting them in a different spot. The problem is at the factory they put them in with a impact gun & over tighten them see if you can a wall stud or even some of that backing that is supposed to be in the wall!

Bob & Carol
Washington St
2017 352RL 2008 Dodge 3500 DRW CC LB 4x4 6.7L
BuilderBob is offline   Reply With Quote
Old 02-03-2018, 07:02 AM   #3
speedster100
Montana Fan
 
Join Date: Jun 2015
Location: owen sound
Posts: 343
M.O.C. #17566
Remember to pre-drill a small hole before relocating..... I added several additional screws along with PL200 adhesive and I also added a strip on the inside (theatre chair side) from top to bottom in the corner and another along the floor all with new screws to the wall and PL200. Better than new and don't expect any further issues, if I do I will add an additional corner piece on the kitchen side stained to the same colour. Don't think it will be necessary as the PL200 and new screws will likely hold fine. Also check the screws in the cabinets below on the kitchen side as they also hold the wall, couple of those were loose which I relocate and added too as well. Couldn't get the adhesive in behind on those ones though.
speedster100 is offline   Reply With Quote
Old 02-03-2018, 08:49 AM   #4
milsutter
Seasoned Camper
 
Join Date: Jun 2015
Location: Granite Bay
Posts: 65
M.O.C. #17499
Send a message via AIM to milsutter Send a message via MSN to milsutter Send a message via Yahoo to milsutter
Thanks for the ideas. I did not think of adding adhesive to it.
milsutter is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Montana RV, Keystone RV Company or any of its affiliates. This is an independent, unofficial site.


All times are GMT -6. The time now is 02:39 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.