Go Back   Montana Owners Club - Keystone Montana 5th Wheel Forum > GENERAL DISCUSSIONS > General Discussions about our Montanas
Click Here to Login

Reply
 
Thread Tools Display Modes
 
Old 04-12-2014, 04:39 PM   #1
woodman
Seasoned Camper
 
Join Date: Feb 2012
Location: Elkhart Lake
Posts: 86
M.O.C. #12256
Leak under bath sink

We own a 2013 Montana 3625RE. When I opened the driver side basement door, I noticed water dripping down from the water supply lines leading to the bathroom sink straight above the basement slam door. There are four PEX lines under the sink, a red, a blue and two whites. The water was coming from some type of water limiting switch that connected the two white lines. It was coming right out of the top of the device and not from the fittings. The red and blue were attached to the faucet and were fine. I was able to remove the device by unscrewing the compression nuts. I could not see anything that impeded it's operation, nothing was broken, but clearly it wasn't working. Fortunately, I found a local RV center that had one of these. They weren't aware of why this device was even used or why it was placed under the sink and neither do I. I installed the device, turned the water supply back on and everything is working fine. Anyone out there know the purpose of the pressure device or why it was located under the bath sink?
woodman is offline   Reply With Quote
Old 04-12-2014, 05:19 PM   #2
CORattler
Montana Master
 
CORattler's Avatar
 
Join Date: Jun 2010
Location: Colorado Springs
Posts: 3,335
M.O.C. #10496
I don't know the layout of your rig but maybe a backflow preventer?? Just a wild guess.
__________________
2010 3150RL
LevelUp, Dual 6 volt batteries, Progressive Industries EMS HW50C, Honda EU2000i Generator, Bridgestone Duravis R250 tires, Torklift Glowstep Revolution Stairs, LED Tail lights
2015 RAM 3500 Laramie SRW LB CC Cummins 6.7L Aisin Trans B&W RVK3600
CORattler is offline   Reply With Quote
Old 04-12-2014, 07:07 PM   #3
rohrmann
Montana Master
 
rohrmann's Avatar
 
Join Date: Oct 2012
Location: Box Elder
Posts: 2,090
M.O.C. #12947
That wouldn't possibly be the backflow preventer that is part of the black tank flush system? I also am not familiar with your rig, but it sure sounds like that is what it is. If you could trace at least one of the lines to the fitting that is labelled as the black tank flush, that would prove it.
__________________
Bob & Becky
2012 3402RL
2012 Chevy 2500HD D/A CC 4WD
rohrmann is offline   Reply With Quote
Old 04-13-2014, 03:36 AM   #4
WeBeFulltime
Montana Master
 
WeBeFulltime's Avatar
 
Join Date: May 2011
Location: Hixson
Posts: 2,734
M.O.C. #11397
It is in fact the back flow preventer for the black tank flush. It is common for them to fail.
__________________
2018.5 Montana 3791RD
2012 F350 SRW 6.7 PSD

Full Timing since September 1, 2010
WeBeFulltime is offline   Reply With Quote
Old 04-13-2014, 11:00 AM   #5
woodman
Seasoned Camper
 
Join Date: Feb 2012
Location: Elkhart Lake
Posts: 86
M.O.C. #12256
Haven't been willing to undo the panels at this time and check to see where the tubing leads to, but I trust that you're right. It was a surprise discovery. Thanks for the input.
woodman is offline   Reply With Quote
Old 04-13-2014, 01:24 PM   #6
Rondo
Site Team
 
Join Date: Aug 2007
Location: Omaha
Posts: 5,524
M.O.C. #7560
Don't know when you got your 3625 RE but if you winterized it and did not blow out or push the "pink stuff" into the black tank backflow valve or preventer and line it could have frozen and split the valve or the line. If you were snowbirding and discovered it down there somewhere, it could just be a backflow valve that has gone bad already. This is a common happening for those valve. If you are still under warranty, I'd take it into the dealer and let them fix it! If you want to do it yourself do a search on the Search Engine above on the subject of black tank backflow valve and you'll see many a post on this problem and a couple of fixes for it also-- replace or remove. It's that simple BUT getting to it is not the easiest procedure. It's easier if it is under the sink, even though it is located up high under the sink than it is when it's located in the wall between the shower and the cabinet. Good luck and update us on what you find out!
Rondo is offline   Reply With Quote
Old 04-13-2014, 01:28 PM   #7
DQDick
Montana Master
 
DQDick's Avatar
 
Join Date: Jun 2011
Location: Wilsey
Posts: 15,273
M.O.C. #11455
The purpose of the device is to keep stuff from your black tank from ending up in your water supply. You're going to be puzzled as to how that could happen. Some folks use their outdoor shower to provide the water for the flush, others use a Y off their incoming water line. A sudden drop in pressure can cause things to siphon back down the line and the vacuum breaker is there to stop that. How likely is it to happen, not very, but on the other hand are you willing to be the one it happens to. Most of us have replaced it with a good one or taken it out all together and use an outdoor one. Outdoor ones are fairly common since restaurants are required to have them on all hose connections. The reason it's required is because as unlikely as it is, it has happened and bunches of people got sick. Why it's under your sink? Keystone puts them wherever it's easiest to plumb based on the model they're building. Be happy you didn't get one behind the shower or behind a cabinet. Two other places they have put them.
__________________
Dick and Joyce, Wilsey, KS & Lakewood, NM
2017 3720 RL
2017 3500 Dodge Maxi Cab
IS and Disk Brakes, 3rd AC, Bathroom door mod, etc.
DQDick is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Water leak under bath vanity Butchy Montana Problems, Problem Solving & Technical Help 8 12-04-2016 09:34 AM
Water lines to bath room sink bubbagulf General Discussions about our Montanas 3 06-17-2016 04:18 AM
Bath Sink Eagleback General Discussions about our Montanas 16 03-03-2015 11:32 PM
Back flow under Master Bath sink? astrungis General Discussions about our Montanas 5 08-19-2014 05:22 AM
Upgrade bath sink faucet ? G McCall Additions & Improvements 7 03-16-2009 05:54 AM

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Montana RV, Keystone RV Company or any of its affiliates. This is an independent, unofficial site.


All times are GMT -6. The time now is 06:00 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.