Shwintek controls

[respearrin]

Does anyone know if I put my controller in emergency mode to retract how to get it back to normal after

[Mikendebbie]

Read this page…maybe item 3 will work for you (I have no personal experience doing this).

[respearrin]

Thank you exactly what I needed to know

[respearrin]

My instructions said go directly to a repair shop I have the new parts but need to extend the slide to do the work terrible design but doable

[dieselguy]

Two motors for each slide. Each motor has a hall effect sensor on top to keep track of rotation for the controller. When you go into the override mode ... it bypasses the hall effect sensor input to the controller allowing you to attempt to move the slide. If the slide is way skewed ... not even that procedure will get it in or out. You'll have to remove a motor and do some serious pushing or pulling. Just more babbling info.

[respearrin]

Yes it did but I keep unplugging the ahead side and got it to go in square. The motor came loose and damaged the sensor on top. Got it back in place have a new motor but need to get the slide back out to replace it. Would have been easier it the emergency mode but didn’t trust doing it Thanks for your response