suburban furnace removal

[blarkman]

I have a noisy fan motor and when I tried to remove thefurnace it will notslide out and seems to be bolted down on left side. the local rv shop says itshould slide out but may be difficult any suggestion. I can slide chamber out about three inches but cannot get enough lift to slide over lip on trimh

[Ozz]

Could have some ducting hooked to it.

[blarkman]

there is no ducting on sides and can lift and twist about an inch on right side, but seems like there is a screw in back on left rear as case will not move and furnace is ducted from bottom

[Ozz]

This may be the same unit as Snfexpress, you might e-mail Michael to check. He removed his, I don't see what unit or year you have.

[blarkman]

I have a 1999 Montana model 2750 and it is a suburban model sf35. I suppose I could cut bottom trimand hope I can slide chamber out that way
bob

[Ozz]

It's just sheet metal and can be repaired, cut away..

[blarkman]

the problem is thatis notthe metal case but the three inch board at the floor I would have to remove and then I do not know if that will allow me to slide the chamber out from the metal casing.