Front landing legs

[sgf]

While un hooking our Monty this past trip we noticed that the upper landing legs are not installed at the same height,never noticed this before, the one on the right,looking at the front is about three inches lower than the left one,anybody know how to adjust these.This height is when the left onw is fully retracted.

[drhowell]

Sounds suspicious! I imagine MIMF2 will be along to give you some advice but I would check inside the front storage and make sure nothing has moved and all the bolts are tight where the drive system attachés to the frame. If your system has the one drive motor the drive shaft from the right side leg to the left side leg should be level. If it is off by 3" you should be able to see it and locate the problem.