3400RL Dining table mount?

[CVNCheng]

Been out a couple times in my 3400RL and notice the dining table has a way of tipping going down the road. There are holes in the table feet where it might have been screwed to the floor originally?

Question is how long of a screw can I use to hold the table down. I'd be concerned with driving a screw through the floor and messing up the slide as it goes in / out.

Any idea how thick the floor is?

Thanks,
Bill

[rmthelen]

The table was originally screwed down from the factory. You will be safe with a screw that is long enough to go through the table leg with with an extra 1/2 to 3/4 of an inch to penetrate the floor.

[twindman]

Just be aware that the carpet 'smooshes' down but still takes up space between the leg and the floor. So getting an exact length is problematic. I was always afraid it was too long and would gouge the inner floor.

[WaltBennett]

Ours came unscrewed, but I added a couple of turnbuckles to the floor and run a strap through the chairs & over the table. Holds everything fine and we can still move the table around if we want.

[CVNCheng]

Thanks all. I think I'll try Walt's idea as it facilitates moving the table when cleaning.


Bill