Seals

[daveinaz]

i'm looking to order some seals for the slide outs on our 08 3400RL. I went to Keystone's website and see a number of seals. Can anyone match what these seals go to?

Thanks to another member, I'm pretty sure these are the bulb seals for the sliders
http://www.trekwood.com/products/145...ed-TPE-1000-Bx

And that these are the wiper seals for the sliders
http://www.trekwood.com/products/145...lip-On-1225-Bx

But what are these seals for?

Keystone just says "bottom"
http://www.trekwood.com/products/145...-Bottom-500-Bx

Keystone just says "flat"
http://www.trekwood.com/products/145...4-Black-250-Bx


Double bulb?
http://www.trekwood.com/products/145...-Bulb-13-Black

slider?
http://www.trekwood.com/products/145...ff-Set-Clip-On

And does anyone know what seal to get to replace the white seal that runs under the nose on the corners? It goes in a channel from under the front of the nose, down to the front landing gear.

Thanks a bunch!

[rohrmann]

http://www.trekwood.com/products/145...-4-White-1000-

[DQDick]

On our old rig I just took a small piece of what I had down to a local camper dealer and bought the same size just better material.

[twindman]

There may be one more type of seal. My 'wipe' seal on the bottom tore off about 3 feet so I was going to replace it. I have done this on top and sides - no problem. But dealer says those on the bottom are not as simple as they appear. Very difficult to remove and replace. Since the only thing the wipe seal does is clean of crap on the bottom of the slide, I am just letting it go. Shouldn't be much of anything accumulate on the bottom, since we are just sitting there when it is open. And there is another seal of some sort, I think, that closes off the opening anyway.

Anyone else ever replace this?