Cleaning the Rubber Molding
Not sure if this has been posted or not as there are still posts that I haven't yet gotten to. This past weekend I tried again to clean the yuk from the rubber molding and the awings on the slide outs. After my wifes nagging I used her method for cleaning anything filthy. That is to put about a cup or cup and a half of Oxi-Clean to a gallon of warm water. I got on top and began to scrub the awings with my extender brush and I couldn't believe it. The mold and mildew just ran off. Much better than all the spray cleaners I've been wasting my money and time on. Just thought I'd pass it on.
Wendell
|