Norcold Refer door replacement

[snfexpress]

Anyone know the steps (or can point me in the right direction) to replacing a freezer door on the refrigerator, along with the wooden panel insert?

My left side freezer condensates and freezes. Thetford determined it was a bad seal and sent me a new door, but I can't find a schematic for it.

Thanks in advance!

[mcgiver2]

Mike if i remember right mine had screw at the top hing you need to undo and the panel look on the edge of door and theres screw that hold the molding remove the side molding and the panel slides out................... i replaced mine about 6 monthes ago on my other montana....

[snfexpress]

Allen,

I see the screw at the top of the hinge, but there are no screws on the molding surrounding the wooden insert.

[mcgiver2]

mmmmmmm i will have to look at mine again, because i changed Ref. in the other montana before i sold it and i had to put the wood panels on both doors, maybe it was hinge side top and bottom i had to take off to replace ? well iam going outside to look at my new montana to see if its the same. i let you know

[mcgiver2]

Mike i just looked at my new one and i see theres no screws but i did see a plug on top and it looks like the top trim comes off to replace the wood panel........i hopes this helps ..........

[Tom S.]

We had a house refrigerator with replaceable panels. The top trim pulled off and the panel slid out. It was a thin veneer, about 1/16 of an inch. I suspect yours will be similar.