Mounting screws for fireplace

[mtlakejim]

Before I tackle pulling the fireplace to get to the TV lift thought I would ask:
Anyone know where the mounting bolts/screws are and what size/type on the fireplace of a 2018 381TH?

[rescue7]

On my 3725 the fireplace just sits there on a lip on the bottom. Lift up, tilt out and pull out.

[rohrmann]

On ours, it is held in with four screws, one near each corner, hard to see, but but it is possible to remove them, and they are installed at an angle into the woodwork.

[BuilderBob]

On are 2017 352RL it's held in with four screws you need to pull the trim off and you can see
them they are Roberson screws

Bob & carol
Washington St
2017 352RL 2008 Dodge 3500 DRW crew cab 4x4 LB 6.7L

[jcurtis934]

And I bet the factory didn't pre-drill the cabinet and used the same screws used everywhere else. End result is cabinet face frame gets split by the screws. Top screws point upwards and you will see them if you look or feel under the heat deflector at the top. Bottom screws on each side at bottom behind flip down flap.

[Time2Travel]

We have a 2018 3701lk and to remove the fireplace, turn off the breaker first. Then to remove the glass faceplate, there are 2 small screws at each end, remove them and lift the glass up and out. The glass sits on little posts that are inside the fireplace. Once that is done, remove the 6 screws, 3 on each side and slide the fireplace out. This unit is a Titan Flame WF series.