|
Found the same thing with our 2005 3400RL.
If your tank is in the rear like mine, what they use is a welded cross memeber to put one side of the tank against, then they screw the other support into place.
Our had a 1 1/2" movement in it from front to back.
I put 3/4" plywood into the space on both the front and back.
Also the small angle iron "L"s that they place on the ends of the tank to keep it from moving side to side, there was only one that was attached and the other was just sitting there.
You should be able to take care if the problem yourself.
Look up were one of the members used a plastic welder to repair a tank I believe he got it from Harbor Frieght.
Good Luck!!
|
Hybrid Mode
