I replaced my sensors with the SeeLevel Gauge and sensors about 1 1/2 years ago. They work very well. They use an external sensor on each tank and IF you get them positioned correctly, they are very accurate. My Fresh water goes to 0 % when I have 3.5 gallons of water remaining. All of my waste tanks indicate 100 % when I have about 5 gallons of room remaining.
Concerning the Gauge mounting, I used a template to cut a hole in the control center and mounted it there. I used the existing gauge wiring to run to the new sensors since the wiring was already at each tank and in the control panel. Just clipped the wires off the factory sensors and picked two colors to use for attaching to the new sensors and control panel gauge.
The gauges have a notch that you cut to indicate which tank that sensor is attached to and inform the control panel gauge.
The included instructions are great.
__________________
Bill & Mary Van Nuys
Leavenworth, KS
2014 3735MK Legacy, Sailun 637s, TST 507RV TPMS, 2 Battle Born 100 AMP Lithium Batteries, Slide Toppers
2015 Chevy 3500 LTZ, 6.6L Duramax 4WD, CC, LB, SRW with Allison Transmission
|