DC lamp short
My 3295RK 2006 has a lamp over the desk in the rear. the lamp is DC using two type 1076 bulbs. The lamp went out.
Funny it blinked a little when i touched the metal lamp shade bracket to the lamp metal attachment point.
I bought new bulbs and installed one. No good. Then the other DC lights went out.
I re-checked the fuses and this time one was burning. I replaced the fuse and it blew. So i removed the new bulb from the lamp and risked another fuse. The fuse survived, and my DC lights are back except for, of course, the desk lamp.
So do I first pull the fuse again, disassemble the lamp and look for loose fittings and connections? (It is becoming obvious that I know not what I do).
Or should I go to the repair man route?
gene
|