|
There are a couple of reasons why this would happen. Onereason is that there is some residual pressure left in the system when you arefinished using it. In a manual system you would rock the lever back and forthto relieve the pressure. With an electrical operated system you might tryswitching between raising and lowering to relieve the residual pressure. The other reason which is probably a worse condition,the seal on the hydraulic piston is by passing oil from one side to the otherso that the piston drifts out just from the weight of the piston and it foot.
You did not say what system you are talking about but if itis a Lippert level up system from what I have read on this forum they are very approachablefor help.
|