Quote:
Originally Posted by masterdrago
Just curious if that would also pertain to the torque value when pre-loading the bearing using the spindle nut. There is really no way those threads are going to be dry. I was also wondering about "finger tight" since my "finger tight" might be a bit different than that of Hulk Hogan. I did notice when removing all the spindle nuts, that they were very, very loose. I almost would not have even used the term "finger tight". They were more like very lightly "pinky tight".
|
We found the spindle nut 'pinky tight' as well. Could this be due to the EZ lube design? Allowing the grease to permeate the bearing?