Quote:
quote:Originally posted by kdeiss
Be carefull when installing the two rubber gaskets if they are not installed properly you will have leak
|
I finally got the line back in place. The valves and gaskets don't appear to have any problems. However, with this project one thing has led to another. The pressure I had to apply to the tanks in order to make enough room for the valves to go back in place created another problem. The grey tank sprung a leak on one of the seams where the fitting looks like it's seam-welded to the tank. I bought some stuff that is supposed to seal almost anything. If I can't get this patched I guess I'm looking at a tank replacement.
OBTW, the bolt was not magnetic so I guess it was brass after all.
This isn't a very good picture but it should show what I'm talking about.
