|
One side at a time then set frame on blocking you'll need the bottle jacks at that point to help raise the axles to pull pins and get your alignment back to insert new pins. I worked from the rear to the front, you may need some help to pull the spring left or right a bit I had a small com-a-long to help me. The link above is a great guide to use. We got by with a 12" C clamp and used deep well sockets and smaller sockets to help push the new wet bolts in. All should go smooth the only problem I had I turned the new wet bolt around and installed them so the grease fittings are accessed from the under side of the trailer. The serrated bolt being pressed into the hanger needed a couple of raps with a 4 pound hammer to help them seat.
|