|
We removed our track because we had mildew or mold coming out from under it. After we removed the bottom track, we discovered it wasn't sealed so water could run out the end and collect under the track. We cleaned the track and the fiberglass then reinstalled it. After it was installed, we used silicone caulk to seal the ends and on the inside and outside where the track meets the fiberglass.
We dry and clean the track after a shower after each shower using rags to soak up the excess water. We then place a rotating fan inside the shower to dry the walls, glass, and tracks.
Eventually we will replace this track with something else.
|