Thread: Attic vents
View Single Post
Old 10-16-2017, 12:05 PM   #9
Established Member
Join Date: Sep 2017
Location: Chadds Ford
Posts: 38
M.O.C. #20532
I remove the cap. There are about 5 spokes inside the base. I twist a piece of drop ceiling wire onto one of the spokes.positioning it toward the outside edge of the base. I then screw the cap back on letting the wire hang outside the vent ( bending it down the side of the base so you can screw the cap on). Where the wire comes out I drill a small hole in the cap and then thread the wire through the cap and give it a couple twists. Cut the excess wire and you should be good to go
Gary and Debbie
2018 Montana High Country 379RD
2015 Ford F350 6.7 Diesel
18K Pull Rite slider using Ford Factory puck system
greische is offline   Reply With Quote