Montana Owners Club - Keystone Montana 5th Wheel Forum - View Single Post

nosticks · 12-19-2012, 08:49 AM

I replaced the porch light with one of these: http://www.rvupgradestore.com/Motion...-p/55-1000.htm
It mounted directly in the original holes from the original light. Works slick. A small led flashes blue to let you know the lights motion detector is armed, and another green to let you know your 12v system is charged enough for the light to operate. The motion detectors, one on each end, can be adjusted for sensitivity.

Oh, and on the caution about increasing incandescent bulb wattage, the replacement scare lights in stainless steel are shipped with the #1295 bulb I mentioned in an earlier post. I just figured I'd sand and repaint my rusty scare lights and upgrade the bulbs when I remove them for service.

12-19-2012, 08:49 AM	#10
nosticks Montana Master Join Date: May 2010 Location: Tampa Posts: 532 M.O.C. #10378	I replaced the porch light with one of these: http://www.rvupgradestore.com/Motion...-p/55-1000.htm It mounted directly in the original holes from the original light. Works slick. A small led flashes blue to let you know the lights motion detector is armed, and another green to let you know your 12v system is charged enough for the light to operate. The motion detectors, one on each end, can be adjusted for sensitivity. Oh, and on the caution about increasing incandescent bulb wattage, the replacement scare lights in stainless steel are shipped with the #1295 bulb I mentioned in an earlier post. I just figured I'd sand and repaint my rusty scare lights and upgrade the bulbs when I remove them for service.