Thread: Attic vents
View Single Post
Old 10-16-2017, 11:05 AM   #9
greische
Established Member
 
Join Date: Sep 2017
Location: Chadds Ford
Posts: 49
M.O.C. #20532
I remove the cap. There are about 5 spokes inside the base. I twist a piece of drop ceiling wire onto one of the spokes.positioning it toward the outside edge of the base. I then screw the cap back on letting the wire hang outside the vent ( bending it down the side of the base so you can screw the cap on). Where the wire comes out I drill a small hole in the cap and then thread the wire through the cap and give it a couple twists. Cut the excess wire and you should be good to go
__________________
Gary and Debbie
2018 Montana High Country 379RD
2015 Ford F350 6.7 Diesel
18K/20K Pull Rite slider using Ford Factory puck system
greische is offline   Reply With Quote